Door limiter worn bushings cause loose doors

Tags: #door · #bushings · #mazda-6-compat

Worn plastic bushings inside the door limiters (ограничители — the arms that stop the door at each open position) cause excessive door movement and a poor closing feel; the door frames rattle when closed ¹.

Fix: replace the limiters on all four doors as a kit — a Mazda 6 part was used for compatibility. Installation is fast, about 30 seconds per door with simple tools. The replacement kit includes lubricant, but the included dry lube dries out quickly; use graphite or silicone grease instead ¹².

Repair-kit alternative — Ozon, Mazda 6 GG 2002-2008: instead of a full limiter swap, a door-limiter-strap repair kit for Mazda 6 (2002-2008 GG generation) fits the X80 driver's door; the Ozon listing part reference is 767099455. Installation takes about 30-40 minutes per door and requires a vise — the limiter mechanism cannot be disassembled by hand. Procedure: remove the door panel (several screws and clips), disconnect the speaker, then disassemble the limiter in a vise. The original limiter straps are fragile and prone to squeaking; ceramic-coated or rubber-lined replacement straps last longer than the stock design ³.

Bushing replacement in a vise: a door check (ограничитель двери) can also be repaired by replacing its bushings in a vise, about 30–40 minutes per door; the parts fit like originals, and the extra gaskets in the kit did not fit but were not needed ⁴⁵. Another member says the check mechanisms of the Mazda 6 GG (2002–2008) are almost identical, so the whole unit can be swapped; a 4-door repair kit (TYPE 14016) is listed for Mazda 6 GH/GJ/GL (2007–2017) ⁶. The GG claim disagrees with door check strap/limiter — sourcing, where Mazda 6 GG limiters are reported not to fit.

Media

Side-by-side comparison of worn vs. new door limiter assemblies

Mazda 6 GG door-limiter repair kit installed and seated like the original part

Related pages

• Door check strap/limiter — sourcing
• Rear arm bushings — numbers and Mazda fit
• Front lower arm bushings — numbers and sizes
• Lower control arm bushings — sourcing
• Door replacement — cost and fitment issues

Sources

This page is compiled from 6 community messages. Every fact carries a numbered reference to its original author and message.

Last updated: 2026-10-29