Intake manifold removal difficulty

Difficulty. Removing the intake manifold on the X80 is reported as notoriously difficult, caused by 2-3 bolts that are extremely tight and sit in hard-to-reach positions. The community jokingly describes the effort required as needing "Sanskrit incantations" — i.e. special patience/prayers rather than a clean mechanical trick¹².

No established procedure. No documented step-by-step procedure for easing this removal was shared in this exchange; the community's practical guidance amounts to persistence, and possibly the use of impact tools on the stuck bolts, rather than any confirmed shortcut¹².

Intake manifold gasket ring — part number. The intake manifold gasket ring part number is 1008014-37K, available on Ozon³.

Related pages

• Intake manifold hose (gofra) replacement
• Catalytic converter removal and P0420
• Generator (alternator) belt removal procedure
• Idle stalling/shaking at stops — likely air-intake leak
• Catalytic converter removal — ECU reflash

Sources

This page is compiled from 3 community messages. Every fact carries a numbered reference to its original author and message.

Last updated: 2026-07-24